標題: [汽車研究] 車標安裝 [列印本頁]

---

作者: easywind2003    時間: 2013-8-15 12:21 AM     標題: 車標安裝

小弟剛拿到新車標了，請問是要把舊車標整個拆下來再安裝?還是直接黏上去就好了，小弟的舊車標已經落漆了，
怕表面會有凹凸不平黏上去會容易掉下來，
有人有經驗嗎??

---

作者: kckc98    時間: 2013-8-15 12:24 AM

我也拿到了~~~不過最近高雄都下雨~~~不太敢貼~~~

---

作者: easywind2003    時間: 2013-8-15 12:31 AM

心癢癢阿~~

---

作者: easywind2003    時間: 2013-8-15 12:54 AM

• 1. Thoroughly Clean the surface area of your existing Ford badges so they are 'squeaky' clean and your finger does NOT slide across the badge easily.
  2. If you are in a slightly cold environment then it may be necessary to warm the badges up with a low setting on a heat gun.
  3. Warm the backing paper first to a reasonable temperature (hot enough not to burn yourself) and then slightly warm the surface of the original Ford badge.
  4. Peel the badge from the backing and stick it carefully to the original badge making sure the edges are lined up and also stuck down. At this point you can slightly warm the edges and apply pressure to make sure they are fully stuck.
  5. The adhesive on the badges is very tacky and they will stick very well.
  我找到了 官網上有教學......
  
• 直接撕開背紙直接黏上標籤.......車標已有託落的話，這樣黏起來表面不會穩嗎?

---

作者: BOK    時間: 2013-8-15 01:04 AM

我的車是MK2,我前面是挖掉用瞬間膠黏,後面是用瞬間膠黏上的挖掉黏會有縫隙因為原車標是浮凸面新車標是平面,給你參考

---

作者: 土豆爺    時間: 2013-8-15 01:49 AM

我是將新車標直接貼上原來車標之上

有車友建議先將要黏貼之位置做好清潔工作並保持乾燥

再用吹風機將新車標之黏膠面加熱後在貼上效果會較好